An official website of the United States government
Abstract Nepheline syenites from the ∼1.2 Ga Ilímaussaq Complex of southern Greenland are examined to assess the utility of anisotropy of magnetic susceptibility (AMS) fabrics as proxies for silicate petrofabrics. Mineral lamination is a relatively common structural feature in cumulate rocks, including in the Ilímaussaq intrusion, but there is little consensus on the process (or processes) responsible for its formation. The Ilímaussaq AMS data are combined with rock magnetic experiments and electron backscatter diffraction (EBSD) measurements to characterize the magnetic mineralogy and compare the magnetic fabrics obtained to the silicate petrofabric. The data show that Na-amphibole (arfvedsonite) is most likely the dominant control on the AMS fabrics in the coarse-grained nepheline syenites (referred to as kakortokites), and that the AMS fabric is inverse relative to the observed silicate fabric. The EBSD data for a kakortokite sample suggests that the petrofabric is defined by arfvedsonite and is wholly planar, with evidence of only weak cross-lineation of c axes. The fine-grained nepheline syenites (lujavrites), two of which have a well-developed lamination carried by Na-pyroxene (aegirine), appear to have composite AMS fabrics that are considered to be a consequence of a mixed aegirine (normal) and arfvedsonite (inverse) response. The combined datasets shed light on the mechanisms of fabric acquisition in both lithologies. In the kakortokites, the AMS fabrics and silicate crystallographic preferred orientations, as well as the lack of observed microstructural evidence for subsolidus intra-crystal deformation, support models invoking gravitationally controlled crystal mats in the development of the macro-rhythmic layering of these rocks. In the lujavrites, the strong planar fabrics revealed by both the AMS and EBSD datasets, with some evidence of subsolidus deformation, point to fabric formation and perhaps even aegirine crystallization at the postcumulus stage. The combination of EBSD and AMS fabric datasets is a powerful means of deciphering the processes responsible for mineral alignment in igneous cumulates.
more »
« less
Beyond the second-order magnetic anisotropy tensor: higher-order components due to oriented magnetite exsolutions in pyroxenes, and implications for palaeomagnetic and structural interpretations
SUMMARY Exsolved iron oxides in silicate minerals can be nearly ideal palaeomagnetic recorders, due to their single-domain-like behaviour and the protection from chemical alteration by their surrounding silicate host. Because their geometry is crystallographically controlled by the host silicate, these exsolutions possess a shape preferred orientation that is ultimately controlled by the mineral fabric of the silicates. This leads to potentially significant anisotropic acquisition of remanence, which necessitates correction to make accurate interpretations in palaeodirectional and palaeointensity studies. Here, we investigate the magnetic shape anisotropy carried by magnetite exsolutions in pyroxene single crystals, and in pyroxene-bearing rocks based on torque measurements and rotational hysteresis data. Image analysis is used to characterize the orientation distribution of oxides, from which the observed anisotropy can be modelled. Both the high-field torque signal and corresponding models contain components of higher order, which cannot be accurately described by second-order tensors usually used to describe magnetic fabrics. Conversely, low-field anisotropy data do not show this complexity and can be adequately described with second-order tensors. Hence, magnetic anisotropy of silicate-hosted exsolutions is field-dependent and this should be taken into account when interpreting isolated ferromagnetic fabrics, and in anisotropy corrections.
more »
« less
- Award ID(s):
- 1642268
- PAR ID:
- 10209679
- Date Published:
- Journal Name:
- Geophysical Journal International
- Volume:
- 223
- Issue:
- 2
- ISSN:
- 0956-540X
- Page Range / eLocation ID:
- 915 to 933
- Format(s):
- Medium: X
- Sponsoring Org:
- National Science Foundation
More Like this
-
-
Anisotropy constants of magnetic materials are typically determined through angle-resolved Ferromagnetic Resonance (ar-FMR) and torque magnetometry, which can be time consuming measurements, thus limiting their utility. The Stoner–Wohlfarth model can be used to numerically fit measured magnetic hysteresis curves to more easily determine these anisotropy constants. To demonstrate this, 10 nm bct FexCoyMnz single-crystal films grown by molecular beam epitaxy on MgO(001) substrates were investigated. The hysteresis behavior measured by vibrating sample magnetometry was least-squares fit against numerically calculated hysteresis curves generated from the Stoner–Wohlfarth model to extract the anisotropy constants. The cubic anisotropy of different compositions of FeCoMn films was at ∼104 J/m3, which is on the same order of magnitude of bct Fe and Co thin films measured by ar-FMR and torque magnetometry techniques.more » « less
-
Sagnac interferometry can provide a substantial improvement in signal-to-noise ratio compared to conventional magnetic imaging based on the magneto-optical Kerr effect. We show that this improvement is sufficient to allow quantitative measurements of current-induced magnetic deflections due to spin-orbit torque even in thin-film magnetic samples with perpendicular magnetic anisotropy, for which the Kerr rotation is second order in the magnetic deflection. Sagnac interferometry can also be applied beneficially for samples with in-plane anisotropy, for which the Kerr rotation is first order in the deflection angle. Optical measurements based on Sagnac interferometry can therefore provide a cross-check on electrical techniques for measuring spin-orbit torque. Different electrical techniques commonly give quantitatively inconsistent results so that Sagnac interferometry can help to identify which techniques are affected by unidentified artifacts.more » « less
-
null (Ed.)SUMMARY Quasi-linear field-dependence of remanence provides the foundation for sedimentary relative palaeointensity studies that have been widely used to understand past geomagnetic field behaviour and to date sedimentary sequences. Flocculation models are often called upon to explain this field dependence and the lower palaeomagnetic recording efficiency of sediments. Several recent studies have demonstrated that magnetic-mineral inclusions embedded within larger non-magnetic host silicates are abundant in sedimentary records, and that they can potentially provide another simple explanation for the quasi-linear field dependence. In order to understand how magnetic inclusion-rich detrital particles acquire sedimentary remanence, we carried out depositional remanent magnetization (DRM) experiments on controlled magnetic inclusion-bearing silicate particles (10–50 μm in size) prepared from gabbro and mid-ocean ridge basalt samples. Deposition experiments confirm that the studied large silicate host particles with magnetic mineral inclusions can acquire a DRM with accurate recording of declination. We observe a silicate size-dependent inclination shallowing, whereby larger silicate grains exhibit less inclination shallowing. The studied sized silicate samples do not have distinct populations of spherical or platy particles, so the observed size-dependence inclination shallowing could be explained by a ‘rolling ball’ model whereby larger silicate particles rotate less after depositional settling. We also observe non-linear field-dependent DRM acquisition in Earth-like magnetic fields with DRM behaviour depending strongly on silicate particle size, which could be explained by variable magnetic moments and silicate sizes. Our results provide direct evidence for a potentially widespread mechanism that could contribute to the observed variable recording efficiency and inclination shallowing of sedimentary remanences.more » « less
-
Abstract Mafic rocks are volumetrically and rheologically significant components of the mid‐to lower continental crust, yet tools to study their fabrics have not been well developed. We examine amphibolites exhumed from mid‐to lower crustal levels in a gneiss dome (Entia dome, central Australia) that display various strengths of mineral lineation and foliation associated with different deformation geometries. Combining petrofabric analysis (electron backscatter diffraction, EBSD) with magnetic fabric analysis (Anisotropy of magnetic susceptibility (AMS), we quantify relationships between AMS‐derived fabrics and crystallographic‐preferred alignment of fabric‐defining amphiboles. We combine single‐crystal AMS data with EBSD data to model amphibole textures and their expected magnetic anisotropy. We formulate a new EBSD‐derived petrofabric index,CAindex, and correlate it with the calculated AMS shape parameterU.CAindexvalues can then be estimated for natural samples using measuredUvalues, leveraging both rapid but texturally low‐resolution AMS and texturally‐resolved but time‐ and analytically‐onerous petrofabric analyses to interpret petrofabrics from magnetic fabric data. In the Entia dome, we identify amphibole c‐fibers (L‐tectonite) in the high‐strain core of the dome, which reflect constrictional strains. In contrast, a‐fibers (S‐tectonites) are dominant near the dome margins and indicate flattening strains. Fabrics measured in different structural subdomains agree well with 2D and 3D numerical models of finite strain distribution in domal structures. Combining textural modeling, AMS measurements, and EBSD analyses allows investigation of previously unexploited records of ductile deformation and flow in amphibole‐bearing rocks. These results can be applied to a wide range of field‐based studies of tectonic and magnetic processes.more » « less
- Free Publicly Accessible Full Text
-
Accepted Manuscript1.0
- Journal Article:
- https://doi.org/10.1093/gji/ggaa355
